AUTONET TV

The Third Brake Light (Third Brake Light Service)

So you thought you only had two brake lights.  Look again and you'll see one in the center at a higher level than the two on either side of the vehicle.  They're sometimes in the inside of the vehicle behind the back window, or they could be in the deck lid, on the roof or on the spare wheel carrier,

But why is that third brake on your vehicle? Experts say it helps prevent rear end collisions. Tests done by installing the third brake light in taxis and fleet vehicles showed fewer rear end crashes in the ones that had the extra light. The third brake light was mandated in new passenger cars in 1986 in the US and Canada.  The requirement was added to new light trucks and vans in 1994.

Sometimes it's difficult to know if your third brake light is even working.  Many vehicles have bulb warning systems that alert you to non-functional bulbs, but not all do. Your vehicle service facility will often check to see if all your turn signals, taillights and headlights are working during routine maintenance inspections, and they may notice that the third brake light is out. 

So, do you have to have it replaced? Not necessarily. Many areas only require one brake light to work in the rear of a vehicle. So even though new vehicles have to have the third brake light, you may not get a ticket if it eventually stops working.  But you may be missing an opportunity to drive a safer vehicle if you don't get it fixed.

In 1995, an insurance institute study found that 1986 model cars were involved in 5 percent fewer rear-end collisions from 1986-1991 than they would have expected without the extra light.

Ask your service advisor for advice.  Keep in mind that in these days of drivers distracted by everything from texting to putting on makeup while driving, you can reasonably conclude that anything that makes you more visible to the vehicle behind you adds one more—possibly life saving—safety margin. 

Economy Transmission and Auto Repair
201 Terryville Road
Bristol, CT 06010
8605891255

What's in a Number? (What Tire Numbers Mean)

You've probably never paid much attention to the writing on the sides of your tires, but they contain a wealth of information.  There's a long combination of letters and numbers that can tell you a whole lot about what tires your vehicle was designed to be riding on.  Let's check out this example found on an SUV: P245/70R17 108T.

The first letter, P, means it's intended for passenger vehicles.  If there's no letter, it means it's a metric tire.  If there's an LT at the beginning or end that means a tire designed for light trucks.

Moving on to our example, the 245 shows how wide the tire is in millimeters from sidewall to sidewall.  The number that follows in our example, 70, means the height of the tire is 70% of its width.  The letter after that in our example, R, describes the type of tire (on this vehicle, radial).  Following that is the diameter in inches, in our SUV example, 17 inches. 

How much load the tires' sidewalls are designed to take is what that next number is all about (108 in our example).  The higher the load index, the more weight the sidewalls can take.  And the last letter is the speed rating of the tire, in our example, T.  The further along in the alphabet that letter is, the higher its speed rating.  So now you know what those letters and numbers mean.  But why are they important?

When you are getting ready to replace those tires, those numbers are telling you what the original equipment was when your vehicle was new.  Sticking with the same rated tires is always a good idea.  If you don't know what you're doing, trying different sized tires and wheels can cause real issues when it comes to performance and safety, considering all the computerized systems now found on vehicles.  When in doubt, consult your service advisor when it comes to buying new tires.  He or she knows what those tire numbers and letters mean… and a whole lot more.

Economy Transmission and Auto Repair
201 Terryville Road
Bristol, CT 06010
8605891255

Not Too Hot and Not Too Cold (Temperature Gauge)

You know your body temperature is supposed to be 98.6 degrees F, 37 degrees C.  Your vehicle has a normal temperature, too, and if you pay attention to it, that can save you some big headaches down the road.

Many vehicles have a temperature gauge on the dash that takes the temperature of the engine's coolant.  Some have a thermometer symbol, some read C-H (cold to hot). Many will have a red zone that shows when water temperature is getting into the danger zone.  Others are digital and have a red warning light that signals overheating.  And some vehicles have a light that goes on when the engine temperature is out of the normal range.

If your vehicle has a gauge, pay attention to it.  If you need help locating it, ask one of our Economy Transmission and Auto Repair experts to give you a quick explanation.  Chances are when the vehicle has been running for 15 minutes or more, the temperature gauge will settle into its own "normal" zone, often just below the midway point.  If you have a digital readout, remember what that "normal" temperature is.  Here's why.

At any point when you're driving, the temperature gauge is the quickest way to get a sense that the engine is running the way it should, a quick health checkup, as it were. Say you're on a 3-hour trip, glance at that gauge every hour or so.  It should always be in the same spot.  If it starts to move one way or the other, you may be able to catch a problem before it gets serious.

Pay special attention to it moving into the hot zone.  The needle on the gauge is the easiest and least distracting way to see an engine heating up, but on a digital gauge, start paying attention if the temperature reaches 240ºF/115ºC or more.

Remember, though, that just because the gauge reads "hot" doesn't mean your engine is on the verge of burning up.  It could be a bad sensor and the engine will be at a normal temperature.  But it also could be a failing water pump, coolant leak or thermostat.  By pulling off the road and observing your engine, it will give you a pretty good idea if it's running hot or not.

If the gauge is too "cold," it could be a broken gauge or thermostat sticking open.  Usually being in the cold range isn't as worrisome, but you should have it checked out since other systems may be affected.

Heat is one of a vehicle's worst enemies, especially when it comes from within.  Know your vehicle's normal temperature and keep an eye on it.

Economy Transmission and Auto Repair
201 Terryville Road
Bristol, CT 06010
8605891255

Such a Little Part (Climate Control Resistor)

You expect your heater/air conditioner to work like it should.  You have a control for temperature and one for fan speed.  You even have a control for what vents the air comes out of. 

Don't be surprised one day if your blower fan develops a mind of its own and starts going crazy.  Most of the time, you may find that it starts blowing at full speed, and nothing you do to try to control it does any good.  This is what may be happening.

Your blower motor has an electronic component called a resistor.  It does what its name says; it offers resistance.  When you want the fan to run more slowly, you turn the fan speed down.  That resistor accomplishes that by turning its resistance up.  When the resistor fails, the power has nothing to slow it and the fan speeds up. 

It's a small part and can fail due to age or corrosion.  It's usually not an expensive part, either, but it's often found in a location that's not that easy for the technician to get to.  That means labor costs will vary depending on the design of your vehicle. 

Occasionally, a faulty resistor can cause the blower motor not to work at all or only partially come on.  But other things can cause that as well, such as a faulty fan switch or vent control. 

This is where a technician's training comes in.  Special equipment can track down precisely where the issue is so you can be assured the correct part is being replaced.

It's just not pleasant when the blower motor isn't following orders.  Have your service facility check it out so you can be the blower's boss, like it should be. 

Economy Transmission and Auto Repair
201 Terryville Road
Bristol, CT 06010
8605891255

A Honking Big Jam (Stuck Horn)

At one time or another, most drivers honk their horn at someone who might be texting at a stoplight or not paying attention when they're driving.  But what happens when you tap on your horn and all of a sudden it won't quit? Everyone's looking at you like you're an angry jerk and all you want to do is turn it off!

It helps to know the basics of what's happening when you honk your horn.  There's a switch in the steering wheel, of course, and when you press on it, it sends power to a relay which then energizes the horn.  Bingo.  Sound.  When the horn sticks on, one of these parts or the wiring has developed a problem. 

With the ear-splitting noise inside your cabin, it may be hard to keep your cool, but do your best to stay calm.  Try pushing the horn several times; it may un-stick the switch if you're lucky.  If not, there are a couple of things you can try.

First, if you can, pull your vehicle off the road and into a spot where you're not disrupting traffic.  If you feel comfortable rummaging around in your vehicle's fuse box, you might be able to pull the fuse that manages the circuit for your horn system.  A hint: the fuse boxes sometimes have a label inside showing which fuse goes to which part of the vehicle. Find the fuse that goes to the horn and pull it out (sometimes there's a fuse-pulling tool inside the fuse box).

But many people don't feel like tackling that.  Yes, you can drive over to a service facility with the horn blaring (not the best idea).  Or call your service facility and see if they might be able to send someone over to where you are so they can shut off the horn.

At the shop, a technician can check wiring, switches, relays and other components to find out what's wrong.  This is something that should be left to a professional for a couple of reasons.  First, repairs around the steering wheel can involve airbags.  Second, some horn components may be part of a vehicle's alarm system. 

The bad news is that your horn may not give you any warning before it starts blaring uncontrollably.  But the good news is that a horn doesn't malfunction all that often, and now you have a plan if it does.    

Economy Transmission and Auto Repair
201 Terryville Road
Bristol, CT 06010
8605891255